A little time,
just for you.
Your ten-minute self-care moment.
Deeper care.
In every mode.
Both invisible near-infrared wavelengths are included in all three modes.
Light, matched
to your skin.
Smooth633 nm
Refine460 nm
Even Tone590 nm
Your skin changes.
Your care adapts.
Firm & Smooth
Clarify & Refine
Calm & Even Tone
Your light.
Your level.
- Power on
Hold POWER for 2 seconds.
- Choose your light
Press POWER to change mode.
- Find your level
Press + for levels 1–3. Start at 1.
Your care ritual
starts here.
Thoughtfully designed. Ready for your routine.
Made to follow
your face.
Wellogic GlowEdit LED Face Mask
LIGHTWEIGHT, FACE-HUGGING COMFORT · TAILORED BY YOU
Your skin changes. Edit your light. Choose care for fine lines, blemishes or dullness, with three intensity levels and a soft liquid-silicone fit. Ten minutes, made for you.
- 3 modes · 3 levels
- Liquid silicone · 3 straps
- 10 minutes · auto-off
At least five 10-minute sessions per full charge, all at Level 3. Shipping and applicable taxes calculated at checkout.
1072 nm Deep NIR.
In every mode.
Choose red, blue or yellow light for your skin’s needs. Every mode also includes both 830 nm NIR and 1072 nm Deep NIR, so you get both with every choice.
Conceptual illustration; not a measured penetration map. Invisible NIR is represented with color.
Deeper care.
Whichever mode you choose.
Two invisible near-infrared wavelengths, included in all three programs—not an extra mode you have to choose instead.
Choose your mode. Set your intensity.
Soft where your face curves.
Soft liquid silicone follows your facial contours. Two side straps and one top strap let you adjust the fit around your head and wear the mask hands-free.
- Eye area · gentle local flex
- Nose contours · soft compression
- Cheeks · curved transitions and rebound
Designed for an adaptable fit. Adjust the three straps without overtightening. Mask: 325 g · Controller: 85 g.
28 days.
See what changed.
Third-party testing followed 36 adults for 28 days. Explore measured changes from the yellow- and blue-light routines, with original study photos for blemishes and eye-area lines.
Original study photos · Unretouched
One participant; individual results vary.
A clearer-looking complexion.
−72.4%Reduction in measured acne area
Acne-area measurements fell after 28 days of the tested blue-light routine.
Day 28 vs baseline · n = 16 · p < 0.05
Original study photos · Unretouched
One participant; individual results vary.
A smoother-looking eye area.
−26.8%Reduction in crow’s-feet visual score
The report’s original image analysis shows the eye-area lines assessed at each visit.
Day 28 vs baseline · n = 20 · p < 0.05
More moisture. Less moisture loss.
+38.1%Increase in measured skin hydration
Skin hydration rose, while measured water loss fell by 22.7% in the same yellow-light group.
Day 28 vs baseline · n = 20 · p < 0.05
Firmness, backed by measurement.
24.5%Reported improvement in firmness parameter F4
The firmness measurement improved after 28 days of the tested yellow-light routine.
Day 28 vs baseline · n = 20 · p < 0.05
Mean F4 (mm·s). A lower value indicates improvement in this test.
A measured shift in skin tone.
+2.9%Increase in skin-tone index ITA°
Standardized image analysis recorded a small, statistically significant shift toward a lighter measured skin tone at day 28.
Day 28 vs baseline · n = 20 · p < 0.05
Mean ITA°. This measures skin color, not the percentage of dark spots removed.
Third-party human efficacy evaluation: 江苏南医大卫生检测中心 (Jiangsu Nanyida Health Testing Center). Report bg-26NYFC-WT025b, 5 June 2026. Individual results vary.
View study design and measurement details
36 adults aged 21–54 with sensitive skin; yellow-light group n=20, blue-light group n=16. Participants used the tested device for 10 minutes nightly after cleansing and basic moisturization for 28 days. The study compared each participant with their own baseline at D0, D7 and D28; it did not include a separate untreated control group.
Hydration, firmness F4, crow’s-feet scores and ITA° shown here are yellow-group results. Acne-area results are from the blue group. The report does not test the red-light program. Percentage changes are taken directly from the report; they are not participant satisfaction rates.
No adverse reactions were reported among the 36 participants during this study. This does not establish universal safety. The study schedule describes the research protocol; for your own routine, follow the product instructions and the mode-specific frequency below.
Image source: report appendices, representative volunteers 38 (eye lines) and 31 (blemishes), D0 and D28. Original images are unretouched. Percentages are the report’s mean participant-level changes, not changes calculated from rounded group means. The before/after photos show individual cases. Hydration, firmness and skin-tone supporting photos are AI-created illustrations, not participants or treatment results. Mean F4 fell from 8.2 to 6.0 mm·s. D7 ITA° change was not statistically significant (p = 0.058); D28 p = 0.026.
Three skin needs.
One GlowEdit.
Firm & Smooth
Fine lines, firmness and elasticity — cared for.
633 + 830 + 1072 nm
Clarify & Refine
Focused care for blemish-prone skin and excess oil.
460 + 830 + 1072 nm
Calm & Even Tone
Care for dullness and uneven tone, with radiance in mind.
590 + 830 + 1072 nm
Deeper care in every mode.
830 nm NIR + 1072 nm Deep NIR, built into all three.
Conceptual skin illustrations, not measured light depth or clinical results.
Ten minutes for your skin.
Room for your everyday.
Cleanse. Wear. Follow with skincare. A light, wearable routine that leaves your hands free.
01Start with bare skin.
Cleanse and dry your face. Use GlowEdit without makeup, serum or moisturizer underneath.
02Make these minutes yours.
Wear your fitted mask for a 10-minute session. Scroll your phone or enjoy a quiet coffee moment while GlowEdit works.
03Finish with your skincare.
The session ends automatically. Remove the mask, then apply your usual serum and moisturizer.
Fully charge the controller for approximately 3 hours with the included USB-C charging cable and a 5V/1A adapter. Unplug the charger before use. Do not use while charging.
First time? Get the fit right.6 illustrated steps
Comfort starts with assembly. Fit the eye protectors and all three straps before your first session.
01Fit the eye protectors.
Match L and R to their eye openings. Point the narrow ends toward your temples.
02Attach the left strap.
Thread a side strap through the left slot. Fold it back and secure the hook-and-loop fastener.
03Attach the right strap.
Repeat with the other side strap through the right slot.
04Attach the top strap.
Thread the top strap through the upper slot, fold it back and secure it.
05Put on your mask.
Place the mask over your face and fasten the side straps behind your head.
06Adjust for comfort.
Adjust the side and top straps until the mask feels comfortable. Keep the fit gentle; do not overtighten.
Connected. Comfortable. Ready.
01Connect the controller.
Securely connect the mask-to-controller cable. This connection powers your mask; the charging cable stays unplugged.
02Press and hold for 2 seconds.
Press and hold POWER for 2 seconds to turn on GlowEdit.
03Choose your mode and level.
Press POWER to cycle through the three modes. Press + to select Level 1, 2 or 3. Start at Level 1.
Read the User Manual for full safety information and the sensitivity test before first use. Stop if discomfort occurs.
Find your light routine →Your GlowEdit.
Ready for your routine.
- GlowEdit LED Face Mask
- Controller
- Three adjustable straps
- Eye-protection accessories
- Mask connection cable and USB-C charging cable
- Storage bag
- User instructions
View all product specifications
- Color
- Gray
- Programs
- 3
- Intensity levels
- 3
- Session
- 10 minutes · automatic finish
- Wavelengths
- 460 / 590 / 633 / 830 / 1072 nm
- Light sources
- 400
- Material
- Liquid silicone
- Battery capacity
- 2600 mAh
- Battery life
- At least 5 sessions per full charge, each at Level 3
- Mask / controller weight
- 325 g / 85 g
- Charging connection
- USB-C
A little clarity before
your first light.
Which program should I start with?
Explore the wavelength combinations above and follow the included instructions. Choose one program for a session and begin at Level 1. Blue light is for healthy, stable skin; pause it when your skin feels sensitive or unstable.
How often can I use it?
For healthy skin with no broken areas or obvious discomfort, use red or yellow modes 3–5 times weekly. Use blue 2–3 times weekly on healthy, stable skin; pause blue when sensitive or unstable. Adjust to your skin and stop immediately if discomfort occurs.
Do I wear it over skincare?
Use on clean, dry skin without makeup, creams or lotions. After removing the mask, continue your usual skincare routine.
Why can’t I see every light source?
830 nm NIR and 1072 nm Deep NIR are invisible to the human eye. The visible color identifies the program; do not look directly into the LEDs to check them.
When will I see results?
The yellow- and blue-light study measured changes at Day 7 and Day 28. It did not assess red mode. Results vary; follow the recommended frequency for your mode and compare your skin over time.
Can I use it while charging?
No. Charge the controller between uses and disconnect the charger before your session. One full charge supports at least five sessions when each uses Level 3.
How do I clean it?
After each use, gently wipe the LED surface and inner lining with a soft, dry cloth. Do not use alcohol-based products, harsh chemicals or abrasive materials. The device is not waterproof.
What if it feels uncomfortable?
Stop the session immediately. Check the fit and read the safety instructions before further use. Consult a qualified professional if you have a skin or medical condition, concerns about suitability or adverse effects.
Make ten minutes your own.
Wellogic GlowEdit LED Face Mask